With this Miracle Box method, you wont need to make a full flash the phone's firmware to fix this "please enter the privacy protection password to unlock" error.
Note
- If this method fails to work for whatever reason then you can always use the SP Flash tool format method @ http://www.techwizng.com/2016/11/how-to-use-sp-flashtool.html
- If you get the inactive start button error when using Miracle, then see @ HERE
Requirements
- Download Miracle Box v2.27a + Loader @ Here
- PC
- USB cord
- Manually Install Mediatek VCOM drivers (see HERE)
# See the video tutorial below by hovatek
How to remove / bypass please enter the Privacy Protection Password using Miracle Box
- Extract the content of the Miracle Box to your desktop. Open the folder and run "Miracle_Loader_2.27A"
- Wait till the Miracle Box program is launched
- Click on the MTK tab
- Click on the Unlock / Fix tab
- Tick Clear Anti-theft
- Click the dropdown box and select your chipset type MT****
- Click the Start Button
- Connect the phone to the PC (must be switched off still with battery inside)
- Press the power button once (this is to ensure that your device is detected immediately). DO NOT hold down the power button else the phone will boot up normally
- Wait for the message ">>Done. (Need to wait a few minutes the phone is switched)"
- Disconnect and power on the phone
No comments:
Post a comment